# The relationship between White Balance and the Matrix.

So… you want to change the look of the colour in your pictures but are not sure how to do it. One of the first things that you need to understand is the relationship between white balance and the colour matrix. They are two very different things, with two different jobs. As it’s name applies white balance is designed to ensure that whites with the image are white, even when shooting under lighting of different colour temperatures. When you shoot indoors under tungsten lights (you know, the one the EU have decided you can no longer buy) the light is very orange. When you shoot outside under sunlight the light is very blue. Our eyes adjust for this very well, so we barely notice the difference, but an electronic video camera is very sensitive to these changes. When you point a video camera at a white or grey card and do a manual white balance, what happens is that the camera adjusts the gain of the red, blue and green channels to minimise the amount of colour in areas of white (or grey) so that they do in fact appear white, ie with no colour. So the important thing to remember is that white balance is trying to eliminate colour in whites and greys.

The Matrix however deals purely with saturated parts of the image or areas where there is colour. It works be defining the ratio of how each colour is mixed with it’s complimentary colours. So changing the white balance does not alter the matrix and changing the matrix does not alter the white balance (whites will still be white). What changing the matrix will do is change the hue of the image, so you could make greens look bluer for example or reds more green.

So if you want to make your pictures look warmer (more orange or red) overall, then you would do this by offsetting the white balance, as in a warm picture your whites would appear warmer if they are slightly orange. This could be done electronically by adding an offset to the colour temperature settings or by using a warming card, which is a very slightly blue card. If you want to make the reds richer in your pictures then you would use the matrix as this allows you to make the reds stronger relative to the other colours, while whites stay white.

# PDW 700 Native White Balance

The PDW-700 cameras are balanced for daylight optically and then corrected electronically for tungsten etc.

Traditionally cameras were balanced for Tungsten and then added colour correction optical filters to get to daylight. This was done as CC filters absorb light and thus make the camera less sensitive. Normally when shooting outdoors in daylight sensitivity is not an issue while shooting indoors under tungsten light you used to need every bit of sensitivity you could get.

The down side to this approach is that tungsten contains very little blue light so to get a natural picture the blue channel was often running at quite a high level of gain which increases noise in the blue channel and thus overall noise. In addition when you rotated in the CC filters to get to daylight the sensitivity of the camera was reduced, so you did not have constant gain.

With the PDW-700 (and also the F350 I believe) the cameras are essentially balanced for daylight, without the use of any CC filters, which helps reduce noise in the blue channel. Then for tungsten shooting you electronically re balance the camera. By doing this the overall sensitivity of the camera is constant whether shooting at 3.2K or 5.6K and you only get additional blue channel noise while shooting under tungsten. If you are worried by blue channel noise you can always correct from daylight down to tungsten with an optical CC filter (80A) and leave the camera set to daylight, although this will reduce the systems overall sensitivity by around 1 and a half stops.